# New RC1325 - how much spindle taper runout is still acceptable?

**URL:** <https://cnc-routers.org/t/new-rc1325-how-much-spindle-taper-runout-is-still-acceptable/139>\
**Category:** Tooling & Workholding\
**Created:** [November 19, 2026, 1:25pm UTC](https://cnc-routers.org/t/new-rc1325-how-much-spindle-taper-runout-is-still-acceptable/139 "2026-11-19T13:25:33Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![walt1962](https://cnc-routers.org/user_avatar/cnc-routers.org/walt1962/32/62_2.png) [@walt1962](https://cnc-routers.org/u/walt1962)\
**Post date:** [November 19, 2026, 1:25pm UTC](https://cnc-routers.org/t/new-rc1325-how-much-spindle-taper-runout-is-still-acceptable/139/1 "2026-11-19T13:25:34Z")

</div>

The machine landed last month and I’ve finally got enough work on it to start caring about finish. Straight cutters in 12 mm collets are fine, but a 90 mm surfacing bit leaves a faint step where the passes overlap, so I’ve started measuring instead of guessing.

With a 0.01 mm dial indicator on the taper, spindle turned by hand, I read about 0.008 mm at the gauge line. Same indicator, fresh ER32 holder in, measuring on a ground pin 100 mm out, and it goes to 0.03 mm. Rotate the holder 180 degrees in the taper and the high spot follows the holder, not the spindle, which I take as the taper being the good part.

What I can’t decide is where the line actually sits. I’ve wiped the taper and the holder shank down with a lint-free cloth and looked for burrs under a loupe, but I haven’t tried a second holder and the indicator is a cheap one, so some of that 0.03 could be the gauge itself.

On a new machine, what numbers would you call normal before it’s worth pushing for a spindle replacement?
