New RC1325 - how much spindle taper runout is still acceptable?

The machine landed last month and I’ve finally got enough work on it to start caring about finish. Straight cutters in 12 mm collets are fine, but a 90 mm surfacing bit leaves a faint step where the passes overlap, so I’ve started measuring instead of guessing.

With a 0.01 mm dial indicator on the taper, spindle turned by hand, I read about 0.008 mm at the gauge line. Same indicator, fresh ER32 holder in, measuring on a ground pin 100 mm out, and it goes to 0.03 mm. Rotate the holder 180 degrees in the taper and the high spot follows the holder, not the spindle, which I take as the taper being the good part.

What I can’t decide is where the line actually sits. I’ve wiped the taper and the holder shank down with a lint-free cloth and looked for burrs under a loupe, but I haven’t tried a second holder and the indicator is a cheap one, so some of that 0.03 could be the gauge itself.

On a new machine, what numbers would you call normal before it’s worth pushing for a spindle replacement?